MP Immersion pumps with open impeller

They are suitable for transferring liquids containing impurities up to 4 mm in size. Their hydraulic components: impeller and feed screw in cast iron, pump body in steel allow them to be used with water, emulsions and oily substances in general, with a viscosity not exceeding 21 cSt (3° Engel). The temperature of the liquid must not exceed 90°C.

 

 

Download PDF catalog Immersion pump type MP

They are commonly used on:
- machine tools
- glass processing machinery
- surface treatment plants
- filtration systems
- spray booths

They are normally installed on a tank with a capacity which is proportional to their flow rate, about 7-8 cm from the bottom. It is important to make sure that the maximum liquid level in the tank is always 5-6 cm lower than the support flange (see figure). Should the liquid be particularly dirty, it is advisable to build a compartment tank in order to allow the sludge to deposit before it is sucked by the pump.

For different uses, please consult our Technical Office.

Typ	Dimensions (mm)										weight
	A	B	C	Ø D	Ø E	Ø F	G	H	Ø I	Ø L	kg
MP 63C	385	180	205	¾"	128	130	180	190	150	9 (n.4)	6,8
	435	230									6,9
	485	280									7
	535	330									7,1
MP 71A	410	180	230	¾"	128	130	180	190	150	9 (n.4)	8,8
	460	230									9
	510	280									9,1
	560	330									9,3
MP 71B	440	210	230	¾"	128	130	180	190	150	9 (n.4)	10,4
	490	260									10,6
	540	310									10,7
	590	360									10,9
MP 80C	517	230	287	1"	190	-	230	245	204	9 (n.4)	16,5
	567	280									17
	642	355									17,5
	757	470									18
MP 90C	590	265	325	1"	190	-	230	255	204	9 (n.4)	22
	640	315									22,5
	715	390									23
	830	505									23,5
MP 100B	625	265	360	1¼"	202	220	250	275	235	9 (n.4)	32
	675	315									32,5
	725	365									33
	775	415									33,5
	955	595									35,5